Datensatz

Zusammenfassung

Studies of controlled hydraulic stimulation experiments with active and passive seismic monitoring conducted in Underground Research Laboratories (URLs) benefit from specific knowledge of hydraulic parameters, close by microseismic monitoring revealing structural details of the rock mass, and detailed evolution of seismicity in response to injection operations. Microseismic monitoring is commonly used to characterize a stimulated reservoir volume, for example, in terms of damage evolution of the rock mass. Since seismic attenuation is affected by damage of the rock volume, active seismic sources covering sizes from the centimetre to decimetre scale may help us to investigate space–time varying attenuation properties in a reservoir. This may allow us to monitor damage evolution of the stimulated rock volume in more detail, also since active seismic sources produce stronger signals leading to a broader frequency range that can be analysed compared to passive seismic signals. Within the STIMTEC project in the URL Reiche Zeche (URL-RZ) in Freiberg (Germany), more than 300 active Ultrasonic Transmission (UT) measurements were performed before and after hydraulic stimulations in two boreholes in the targeted rock volume, an anisotropic metamorphic gneiss. The signal-frequency content ranges between 1 and 60 kHz. Assuming scattering attenuation to dominate over intrinsic attenuation, we here apply the single isotropic scattering model. S-coda waves of 88 spatially representative UT measurements are used to estimate the coda quality factor (QC). We obtain stable QC estimates for centre frequencies of octave-width frequency bands between 3 and 21 kHz. We group neighbouring UT measurements to stabilize the observations and form eight UT groups in total, covering different depth intervals in three boreholes and four different time periods to investigate scattering attenuation changes in a spatiotemporal manner. Our final mean QC (⁠QC¯¯¯¯¯¯¯⁠) estimates show characteristic frequency-dependence as observed at the field scale in geological reservoirs. We find temporal variations of QC are strongly connected to hydraulic stimulation, and these variations are more significant than those resolved from velocity changes. QC¯¯¯¯¯¯¯ estimates at frequencies above 15 kHz indicate healing of injection-induced small-scale fractures during a two-months post-stimulation phase. Larger fractures, mostly sampled by lower frequencies (<15 kHz), seem to be more persistent with time (over 15 months). We observe spatial differences of QC¯¯¯¯¯¯¯ values near the mine galleries (driftway and vein drift) and relate these observations to different extents and characteristics of the galleries’ excavation damage zones. Our results further support previous assumptions based on borehole televiewer logs and mapped structures of an existing fault with larger damage zone that crosses the stimulated rock volume NW-SE between the galleries. We conclude that the coda analysis of active UT measurements complements established imaging methods used during experiments in URLs. In particular, coda analysis is a powerful tool for the detection of damage zones and for monitoring local fracture networks with immediate application for imaging georeservoirs considered for exploitation or underground storage of gases and liquids.